How to Use Finalcrete

Finalcrete is designed to adhere to most surfaces including all concrete and when a thin overlay topcoat is desired. Use conventional tools; trowel, brush, roll-on, sponge, squeegee or spray. Variable slump consistency up to slurry can be obtained. Yield: Trowel (0.39 cu.ft./unit.) per 20kg (44 lb.) bag.  DO NOT ADD WATER.

Surface Preparation

Concrete must be structurally sound and free from dust, loose particles and all foreign contaminants. Mechanically remove all spalled concrete. Remove bond breakers, such as oil, grease, sealants or other coatings by high pressure water blasting or wet or dry sandblasting. Repair holes, defects, irregular surfaces, weak mortar joints before finishing. Pre-water substrate in hot climate with clean water to saturated surface dry (SSD) condition, with no standing surface water.

Trowel Mixing Instructions

  • Trowel Mix – Ratio 1:3 by volume (ONE part Liquid A to THREE parts Dry B)
  • Tools: Clean mixing bucket, heavy-duty power drill with mortar paddle attachment. Clean tools with water immediately to avoid product drying.
  • Pour ONE part of Liquid A into a clean bucket.
  • Gradually add THREE parts of Dry B.
  • Continuously mix with paddle until desired consistency is reached.
  • Do not mix more than can be used within 20-40 minutes.
  • ALWAYS ADD LIQUID TO CONTAINER FIRST.

Spray Mix Instructions

  • Spray Mix – Ratio 1:2 by volume (ONE part Liquid A to TWO parts Dry B)
  • Tools: Clean mixing bucket, heavy-duty power drill with mortar paddle attachment.
  • Yield: Spray approximately 10L per 20kg (44 lb.) bag
  • Pour ONE part of Liquid A into a clean bucket.
  • Gradually add TWO parts of Dry B.
  • Continuously mix with paddle until desired consistency is reached.
  • Pour contents into stucco hopper and spray

Caution

Causes Burns. Do not get in eyes, on skin or clothing. Do not breathe fumes. Handle with care. Keep out of reach of children. Use only in well-ventilated area. Wear rubber gloves, safety glasses and approved dust mask.

First Aid

This product contains cement and may cause eye and respiratory system irritation.

If swallowed, call a Poison Control Centre or physician immediately. Do not induce vomiting. In case of contact with eyes, rinse well with water for a minimum of 15 minutes. In case of skin contact, rinse well with water. If on clothes, removes clothes.

If breathed in, move person to fresh air. Consult the MSDS data for more information.

Note: For best results always use Component A with Component B.

One (1) 20 kg bag Dry B requires one (1) 3.7L jug of Liquid A.